This
product has permanent anti-static function because
it uses conductive staic network formed at the interface
of plastic particles.Its appearance looks like the
pattern of marble.So it has good decoration effect
and is wide used for program machine room,computer
room,control room of electric power,cleaning and purification
workshop of telecommunication,electric power,electronics,micro-electronics
and medicine industries and other places where it
is necessary to be protected from electrostatic discharge.
Features:Hardwearing
homogeneous contract tile floor covering Technical data: Specification:
Size:600〜600mm,610〜610mm
Thickness:1.5mm,2.0mm,2.5mm,3.0mm Technical data: Anti-corrosion:
HCL OK NaOH aqueous solution OK
Alcohol OK Gasoline OK
Acetone OK Normal detergent OK
Item
System resistor
Decay time
Rate of size
change of heating
Amount of wear
Combustion property
Starting voltage
Standard
DIN51953
GJB2605-1996
5000V-50V
GB4085-83
SJ/T11236-2001
GB4085-83
SJ/T11236-2001
GB4609-84
FV-O
SJ/T11236-2001
SJ/T10694-1996
Technical data
104-106(conductive)
105-109(static-dissipative)
<2昼
<0.25%
<0.02g/cm2
<10昼
<100V
Brief Introduction
of Installation
(1)the requirements
of foundation
1.The ground should be waterstone ground,caramic tile groud,wooden
ground or cement ground.
2.The ground should be smooth and level.Its unflatness should
be less than 0.2%.
3.The ground should have enough strength and no the phenomenon
of sand comimg out and separation.
4.The ground should be dry.It is necessary for a new ground
to dry about 30days.
(2)Procedure of construction
Clean the ground★spread the earthing conductive net★lead out
the earthing line★coat strong adhesive★coat conductive adhesive★lay
floor★welding floor★cleaning★inspect properties
(3)Maintenance of floor
1.It is not permitted that sharp and rough heavy matters scribe
and drag on the surface of floor and that personnel who wear
shoes with nails walk on the floor.The floor should be kept
cleaning.
2.It is not permitted that the chairs which have black rubber
cushion put on the floor in order to avoid black sulfied polluting
its surface.
3.If there are oil or dirty on its surface,it may be cleaned
with detergent.If there is scribed sign,if can be recovered
through fine abrasive paper.
4.If there are heavy oil and dirty caused by install equipments.Our
factory has special washer to clean them.
5.Our factory also has anti-static wax that can be used to
maintain the floor.In general,it should be coated one time every
six months.If the personnel walking on the floor are busy,it
should it should be coated every three months.
